Getting started

1. Activate the board

1. Connect the BP to the board by first sliding it into place on the nose- side of the BP compartment
2. Push down the rotary lock gently but firmly in order to lock the BP into the BP compartment
3. Place the PKL on one of the receptacles located on each side of the LED screen
4. When the BP is connected to the board, the LED’s will switch from white to green
5. When the HC is connected, you will see a large ”0” on the display

2. Activate the HC

1. Activate the HC by pressing the throttle down firmly all the way down and then release.
2. The HC deactivates/shuts off automatically after 45 seconds. Simply repeat the activation procedure to reactivate it

3. Pair the HC

How to pair my hand controller?

4. Ride the board

1. Start of by laying on your belly and gently push the throttle, to get a feel for the sensitivity
2. As you improve and get comfortable with the throttle, slowly start to get up on your knees by gently pulling your knees towards you chest
3. Keep a proper, even grip on the throttle, so that the board has enough speed to plan and become stable
4. When you feel comfortable on your knees, try standing up by putting one of your feet into the foot strap after the other (slowly). If you feel more comfortable without the foot straps, simply remove them
5. If/when you fall, simply climb on the board from the back and reconnect the PKL and try again
6. Now you’re basically ready to challenge the Factory team!