Long term storage (winterization)

Long term storage (winterization)

Anytime the Flex BP is not in use for longer periods of time, always try to keep the state of charge between 20% and 80% (4 LEDs). Before you use it again, charge it fully (5 LEDs) to enjoy the full capacity of your Flex BP. Failure to store the Flex BP at a recommended state of charge can deplete the cells beyond recovery and render the entire Flex BP unusable (an action not covered by the Awake Care© or warranty).

Make sure to adhere to the following steps for winterization:

1. Rinse all parts of the board and battery with fresh water, and make sure to let everything dry properly 
2. Spray the connector modules on both the board and the battery with a contactor spray
3. Charge the battery to 80% (four bars on the LED display). 
4. Disconnect the PKL (you can leave the Flex BP on the charger if convenient) 
5. Check the battery every few weeks by simply connecting the PKL. 
6. When you notice that the charge level has dropped to three bars on the LED display, let the Flex BP charge for 15-20 minutes, or until the charge level has gone up to four bars on the LED display.