Katja Djukic

If you are done for the season and want to store you gear for a longer period of time (longer than 2 months) adhere to the below listed steps to ensure that your equipment is stored correctly. ...

NOTE! This procedure only applies to Awake Flex Hand Controller Version 1. How to tell if you have a version 1 controller: If the hand controller shows a large Awake logo on startup and do not vibr...

1. Plug in the Controller charger to a power outlet.       2. Place the hand controller in the receptacle on the controller charger.     3. See the charging progress on the controller display.   ...

  WHITE signals  Idle mode – When PKL is connected on Flex BP outside the board GREEN signals  All systems are fully functioning  BLUE signals  The battery is connected to the Awake App  ORANGE ...

Customise your ride by fine-tuning your settings with 10 Power Levels per Ride Mode. Control them from the water with the hand controller. 1. Deactivate the battery by removing the Power Key ...

Always perform the below listed steps before every ride 1. Make sure the Flex BP and Flex HC are fully charged and activates properly. 2. Check CM and BP connector pins for corrosion and potential...

Always perform the below listed steps after every ride 1. Rinse off the equipment with freshwater to prevent corrosion on the metal parts and to remove sand grains and other sharp particles that ca...

1. Place the footstraps for the desired riding style, standard or goofy. Standard = Left foot front Goofy = Right foot front   Not sure if you’re standard or goofy? Stand straight and ask someo...