Katja

1. WARNING indications 1.1 Overheating motor The Flex BP will switch to ECO mode to preserve the motor. Recommended actions: Stop riding as soon as possible and wait for the motor to cool dow...

  WHITE signals  Idle mode – When PKL is connected on Flex BP outside the board GREEN signals  All systems are fully functioning  BLUE signals  The battery is connected to the Awake App  ORANGE ...

Content1. RÄVIK Inventory2. Install the fins3. Charge the battery4. Connect the battery5. State of charge6. Download the Awake Link app7. Pair the controller8. Video tutorial RÄVIK Inventory ...

Safety information  2.1 General safety precautions  2.1.1 Limitation on who may operate an Awake RÄVIK : Awake recommends a minimum operator age of 16 years old. An adult shall always be present a...

Charge the battery 1. Make sure that all connection points are dry and free from debris.   2. Connect the charger to a power outlet, place the BP on the charger, lock it and activate it wi...

Always perform the below listed steps before every ride 1. Make sure the Flex BP and Flex HC are fully charged and activates properly. 2. Check CM and BP connector pins for corrosion and potential...

1. After each ride, rinse all modules and connectors with freshwater and clean the jet from any debris. For maximum performance and corrosion protection, treat the connectors on both board and b...

Installing the Wings 1. Fasten the screws with the complimentary Allen key. 2. When receiving your Powder or Fluid wings set, you will find Shims for both front and rear wings. See the Awa...