Re-Calibrate HC V.1

NOTE! This procedure only applies to Awake Flex Hand Controller Version 1. 
How to tell if you have a version 1 controller: If the hand controller shows a large Awake logo on startup and do not vibrate, it a version 1 controller. The version 1 controller also does not show a QR-code for pairing.

Re-Calibrating the Magnet Sensor

When you're out on the water, precision and accuracy are essential for a safe and enjoyable experience. Your HC (Hand Controller) plays a crucial role in controlling your water sports equipment, and it's vital that it provides accurate feedback.

If you notice that your HC is displaying anything other than 0% when the throttle is not pressed, it's time to
re-calibrate the magnet sensor. Here's a step-by-step guide to help you with the process:

1. Push down the throttle fully. Ensure that the throttle is in its lowest position, fully depressed.

2. Place a PKL (Power Key Leash) on the side of the HC. Position it securely along the side of the HC.

3. Release the throttle slowly while keeping your eye on the PKL. As you release the throttle, slowly and deliberately swipe the PKL up, moving it along the side of the HC.

This step is crucial in re-calibrating the magnet sensor to ensure that it accurately reflects the throttle's position.

4. Check the magnet sensor's response. After following the above steps, the magnet sensor should re-calibrate itself. You can verify this by looking at the HC's display. It should now show 0% when the throttle is not pressed.