Always perform the below listed steps before every ride
1. Make sure the Flex BP and Flex HC are fully charged and activates properly.
2. Check CM and BP connector pins for corrosion and potential debris (e.g. sand). To get the best possible connection between CM and BP, apply contact spray.
3. Make sure that the fins are intact and properly in place by checking that the fin-screw is not loose.
4. Ensure that the jet system is cleared from marine debris and is spinning without resistance. This is done by either manually turn the shaft or the impeller. NOTE! the BP can not be installed in the board when preforming this action!
|
CHECKLIST 1. Charge the Flex BP(s) 2. Charge the Flex HC(s) 3. CM pins are free from corrosion and salt residue 4. The two (2) O-rings on the CM connector are present 5. Make sure that the jet is free from debris 6. Install fins and make sure they are properly tightened 7. Install foot straps (if available) 8. Activate BP and connect to the Awake app 9. Update the BP if update is available 10. Install BP in board, activate the HC and make a dry run |
Comments
0 comments
Please sign in to leave a comment.